LDG AT-1000 (1 KW) Great High-Power Autotuner for 6 through 160 m

1000-W SSB • 750-W CW • 500-W Digital AT-1000 Autotuner (blemished) SOLD OUT $299 (only one left) Includes 1 ea. Coax Cable and 1 ea. Power Cable Blemished Units have very minor cosmetic blemish(es) on the case. SOLD AS IS! Two year warranty on electronics only. This outstanding autotuner has been discontinued. Replacement Blub for AT-1000 $5 An Autotuner for use with your amplifier! No more knob spinning or inductor rolling. Tunes your antenna in 1 to 8 seconds for when you QSY either in the same band or to a different band! Easy installation and use make this the choice for any Amateur Radio Operator with an amplifier. Operation is simple: Place amplifier in standby Transmit a steady carrier Tune and verify SWR is less than 2:1 Return your amplifier to operate and have fun with QRO! The AT-1000 covers 1.8 to 54 MHz continuous coverage (Please see specifications for specific power ratings). The microprocessor that controls all the tuning actions has safety software built in so that if you accidently try to tune or fine tune the AT-1000 with more than 125 watts (1:1 load), it will lock itself to protect the relays. Just about any antenna can be tuned with the AT-1000. The antenna must be between 6 to 800 ohms (approximately 10:1 SWR) in order to bring the SWR down to 1.5:1. If you use ladder line or long wires (random length or otherwise), add an appropriately rated Balun and you're ready to go! This Desktop Autotuner is a beautiful addition to your shack and a companion your amplifier shouldn't be without.   SPECIFICATIONS Microprocessor controlled Switched L tuning network Back-lit cross needle meters Continuous coverage 1.8 to 54 MHz Power rating HF (1.8 to 30 MHz):   1000 Watts Single Side Band   750 Watts CW   500 Watts Digital (RTTY, Packet, etc.) Power rating 6 meters: 100 Watts Capacitor / Inductor fine tune controls Tuning time: 1 to 8 seconds, 4 seconds average Antenna impedance: 6 to 800 Ohms (approxamately up to 10:1 SWR) Tuning power: 20 to 100 watts maximum, constant carrier Relay protection software prevents tuning:   Greater than 125 watts into a 1:1 SWR load   Greater than 75 watts into a 3:1 SWR load Soft touch buttons Includes 6 foot power cable Power requirements: 11 to 15 volts DC @ 1 Amp (user supplies power source) Enclosure sizes: 9" x 13" x 3" Weight: 6 pounds Click here for detailed information and specifications. (Requires Adobe Acrobat Reader. Use Browser BACK button to return.)